Name: JAKO Fig. 49 Pressure gauge tap with clamping sleeve spigot connection | Highest precision since 1949
Brand: Accessories

Fig. 49 DIN 16263 Pressure gauge cock (form A) clamping sleeve spigot connection with test connection

Symbol image

Fig. 49 DIN 16263 Pressure gauge cock (form A) clamping sleeve spigot connection with test connection

Application and performance features of the pressure gauge tap

Shut-off and throttling device with plug, for installation between pressure gauge and upstream cooling section, e.g: Siphon
Test connection for a test pressure gauge to check the function of an operating pressure gauge on the same pressure line during operation.
The tap/plug can be used to set 3 operating positions: venting position (pressure gauge is depressurized and vented), measuring or transit position (pressure gauge is pressurized); blow-out position (the medium is discharged into the open)
In the fourth position of the plug/tap, the test measuring device is switched to continuity via the test connection at the same time as the operating pressure gauge
Test connection is a test stud M 20 x 1.5
Pressure tapping side with spigot G1/4B or G1/2B and pressure gauge connection with clamping sleeve G1/4B or G1/2B;
Suitable for gases, vapors and liquids from -10°C to +50°C
Highly resistant to corrosion and chemicals in stainless steel design Maximum operating pressure up to 16 bar

Type standard	DIN 16263 Form A
Shut-off element	Fig. 49 Chick made of copper alloy Fig. 490 Chick made of CrNi steel 1.4571
Sealing	Sealing and lubricating grease
Connection gasket	Pressure gauge Flat gasket
Handle	Plastic
Material	Fig. 48 Housing Copper alloy Fig. 480 CrNi steel 1.4571
P max	16 bar
T max	-10°C to +50°C

	L	l	SW1
G1/2 B	42	99	27

^{All dimensions in millimeters.}

Special threads (e.g. NPT, BSP, metric)	from 1 pc.
Works certificate 2.1 (EN 10204)	from 1 pc.

^{Other special versions on request.}

Pressure connection	Measuring device connection
G1/2 B, spigot	G1/2 B, clamping sleeve
G1/4 B, spigot	G1/4 B, clamping sleeve

^{Other special versions on request.}

Please observe the relevant standards and laws, as well as the installation and operating instructions for pressure gauges.

In particular, we would like to draw your attention to the suitable media with regard to material resistance and their maximum media temperature.

This specification refers to our current standard with regard to design, dimensions and materials. JAKO Messtechnik GmbH reserves the right to make changes or modifications without prior notice.